Fully equipped plug inclusive shells and break protection for the building of own diagnose cables.
Corresponding to nach SAE J1962 / ISO 15031-3 Norm with centre bar type A (passenger cars) and with hurrying ahead ground pins.
The pins are already soldered finished on a small plate. The most important 9 pins are led into the center, where a cable or a pin row can be soldered:
- Housing bowls green transparency
- Huge housing (ca. 6 x 4,5 cm)
- All 16 pins are included
- Pins for soldering
- Tension relief
- Housing bowls for screwing (4 screws incl.)
- Ideally for the self-'s building of diagnostic adapters
||CAN High (J-2284)
||ISO 9141-2 K Ausgang
||CAN Low (J-2284)
||ISO 9141-2 L Ausgang
OBD II topview jack