Fully equipped plug inclusive shells and break protection for the building of own diagnose cables.
Corresponding to nach SAE J1962 / ISO 15031-3 Norm with centre bar type A (passenger cars) and with hurrying ahead ground pins.
- Elongated housing (without plug ca. 9 x 4,5 cm)
- Hole for 5 mm LED
- Screw-socket for PCB
- All 16 pins are included
- Pins for soldering
- Tension relief
- Housing bowls for screwing (4 screws incl.)
- Ideally for the self-'s building of diagnostic adapters
| Pin |
Beschreibung |
| 2 |
J1850 Bus+ |
| 4 |
Fahrzeug Masse |
| 5 |
Signal Masse |
| 6 |
CAN High (J-2284) |
| 7 |
ISO 9141-2 K Ausgang |
| 10 |
J1850 Bus |
| 14 |
CAN Low (J-2284) |
| 15 |
ISO 9141-2 L Ausgang |
| 16 |
Batterie-Spannung +12V |
OBD II topview jack
